Reconfiguring RE200 again and again after power outage
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Reconfiguring RE200 again and again after power outage
I am currently facing an issue where I have to again and again reconfigure the TP Link Extender after a power outage. This makes it equal to unusable since it should remember the host device it connected to before the outage. But rather it starts displaying only the power light and shows the TP Link Extender Wifi on my end devices which when you connect to, it asks to reconfigure.
Is this a expected behaviour of the RE200 or am I missing some setting to save the configuration?
1 Accepted Solution