Ex230v bridge mode for ER605
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Dear Experts,
I have an EX230V from my ISP and I have purchase an ER605 for using 2 ISPs for continuity of speed and higher availability.
Switching the EX230V into bridge Mode is a preparation for the ER605 to handle it as a data source on the WAN port. Therefore I would like to know how to switch the EX230V into bridge mode and how to access it in the future when it is in bridge mode.
The ER605 is then the router of my choice. I didn't find any guide how to get it into bridge memoafrstode.
Thank you for your help!
Nemoadest
Ex230v is an ISP provided router and it might not have a bridge mode option for its WAN type connection:
Probably it's best to contact your ISP and ask whether that's possible or not.
In general modem routers have that option and the guide for setting them in bridge mode is here.
If after all, bridge mode is not possible, probably a DMZ to the ER605 WAN IP address would be the best approach.
Ex230v is an ISP provided router and it might not have a bridge mode option for its WAN type connection:
Probably it's best to contact your ISP and ask whether that's possible or not.
In general modem routers have that option and the guide for setting them in bridge mode is here.
If after all, bridge mode is not possible, probably a DMZ to the ER605 WAN IP address would be the best approach.