Topography Help
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have a Virgin cable Hub3 which I have switched in Modem Mode and connected to my main Deco M5, with two satellite Deco M5's working on wi-fi.
In Modem Mode only one of the Hub3 ethernet ports is operable - the one connected to the main Deco M5.
My desktop computer is connected by ethernet cable to the second port of my main Deco M5.
I need a further couple ethernet ports and have ordered a TP-Link TL-SG1005D, 5 Port Gigabit Ethernet Network Switch.
The only clue I have found is the topography diagram below.
Should I wire the Ethernet Network Switch after the main Deco (as below) - I assume that the wi-fi would still be working from the Main Deco?:
Yes, this is the only way, for Deco mesh running in its default Router mode.
You will have more flexibility if you switch Deco mesh to run in Access Point mode. For that, you will have to restore original Hub 3 mode, undoing its switch to Modem Mode.
Benefits: all Ethernet ports of Hub3 and Deco nodes and switch that you ordered will be on the same LAN and devices connected to them will see each other. If you have enough ports on Hub3, you can wire everything directly to it.
If you still need that TP-Link TL-SG1005D, you can connect it directly to Hub 3, Main Deco - to one of Hub3 or switch ports, for example like this:
See Switching a Deco to Access Point (AP) Mode
Yes, this is the only way, for Deco mesh running in its default Router mode.
You will have more flexibility if you switch Deco mesh to run in Access Point mode. For that, you will have to restore original Hub 3 mode, undoing its switch to Modem Mode.
Benefits: all Ethernet ports of Hub3 and Deco nodes and switch that you ordered will be on the same LAN and devices connected to them will see each other. If you have enough ports on Hub3, you can wire everything directly to it.
If you still need that TP-Link TL-SG1005D, you can connect it directly to Hub 3, Main Deco - to one of Hub3 or switch ports, for example like this:
See Switching a Deco to Access Point (AP) Mode