I am encountering issue while trying to establish an EasyMesh network with my Mercusys routers. Specifically, I am experiencing difficulties with my MR50G router.

To provide you with a comprehensive overview of my setup, I have configured my MR90X router as the main router, with MR70X and MR50G serving as satellite routers using LAN connection. (EasyMesh Ethernet Backhual) While MR70X seems to be functioning correctly as a satellite router, I have encountered several issues with MR50G.

Upon inspecting the configuration settings of the MR50G router, I noticed that no channels are assigned for either the 2.4GHz or 5GHz frequency bands. Additionally, in the 2.4GHz configuration, a MAC address is assigned, but the 5GHz band shows '00-00-00-00-00-00' as the MAC address. As a result, there is no WiFi signal coming from the MR50G router.

This issue was resolved when I reset the router, which then switched to EasyMesh mode and started working fine. However, if either the main MR90X router or the satellite MR50G router is restarted, the same issue reoccurs. This problem might be related to the firmware of either the MR90X or the MR50G. I also attempted to fix the issue by downgrading the MR50G firmware, but the problem persists.

For your convenience, I have attached screenshots of the configuration settings of both the main router (MR90X) and the MR50G router, including every EasyMesh configuration page.

MR50G router's main page.

MR50G Host Router page

MR50G router config page.

MR90X Mesh devices list page

MR90X router Mesh Device config for MR50G

If required any other information from my end just let me know. Thank you!