Alantina TL-ANT2415D settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Alantina TL-ANT2415D settings

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Alantina TL-ANT2415D settings
Alantina TL-ANT2415D settings
2013-09-25 21:12:36
Region : Turkey

Model : TL-ANT2415D

Hardware Version : V1

Firmware Version :

ISP : TooWay


Do you need Alantina TL-ANT2415D to private settings
Pre-installed
Or you just need to plug

i use it with TL-WA5210G

But very bad
Do not give a good performance
Knowing that rise from the earth, building 30 m pipe + 4 m = 34 m

Please help
  0      
  0      
#1
Options
1 Reply
Re:Alantina TL-ANT2415D settings
2013-12-09 10:59:32
The problem comes from the cable...It is too long !!

The built-in antenna gain of TL-WA5210G is 12dBi. Considering the loss on the connector and your 34m cable, I dont think using a 15dbi omni antenna can have a good performance as the built-in one in long-distance transmission.
Even with the same gain value, a omni antenna needs several times the input power to achieve the same distance of a directional antenna.

But you can try your luck by some adjustment in the webUI.

1. go to the Management Page -> Wireless -> Wireless Advanced -> Antenna Setting, choose "External Antenna" instead.
2. set the highest transmit-power.
3. Wireless->Distance settings should be correct.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 698

Replies: 1

Related Articles