WR740N, Access to internet through WAN secondary IP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
WR740N, Access to internet through WAN secondary IP
Region : Iran
Model : TL-WR740N
Hardware Version : V4
Firmware Version :
ISP :
Hi everybody
Please at first see attached file(Scenario).
Wireless ADSL Modem(Left side of scenario) working in bridge mode(DHCP Disabled).
Router in first floor(Right Side) connected to modem with PPPoE connection(DHCP Enabled).
ADSL modem in second floor(Right side) is only used as switch
Router is connected to internet and everything is ok and also PC in the first floor(Right side) have internet access.
From mentioned Router and PC, the wireless modem and switcher is accessible(testing with ping, and no problem)
here is the system routing table of Router
System Routing Table
ID Destination Network Subnet Mask Gateway Interface
1 172.16.200.1 255.255.255.255 0.0.0.0 WAN
2 192.168.1.0 255.255.255.0 0.0.0.0 WAN
3 192.168.0.0 255.255.255.0 0.0.0.0 LAN & WLAN
4 0.0.0.0 0.0.0.0 172.16.200.1 WAN
I want to all client with 192.168.1.X can access to internet through Router(Not wireless modem, because it's now in bridge mode and also I want to control bandwidth with router). I set 192.168.1.200 as gateway for clients but still can not connect to internet.
Any Idea?
Model : TL-WR740N
Hardware Version : V4
Firmware Version :
ISP :
Hi everybody
Please at first see attached file(Scenario).
Wireless ADSL Modem(Left side of scenario) working in bridge mode(DHCP Disabled).
Router in first floor(Right Side) connected to modem with PPPoE connection(DHCP Enabled).
ADSL modem in second floor(Right side) is only used as switch
Router is connected to internet and everything is ok and also PC in the first floor(Right side) have internet access.
From mentioned Router and PC, the wireless modem and switcher is accessible(testing with ping, and no problem)
here is the system routing table of Router
System Routing Table
ID Destination Network Subnet Mask Gateway Interface
1 172.16.200.1 255.255.255.255 0.0.0.0 WAN
2 192.168.1.0 255.255.255.0 0.0.0.0 WAN
3 192.168.0.0 255.255.255.0 0.0.0.0 LAN & WLAN
4 0.0.0.0 0.0.0.0 172.16.200.1 WAN
I want to all client with 192.168.1.X can access to internet through Router(Not wireless modem, because it's now in bridge mode and also I want to control bandwidth with router). I set 192.168.1.200 as gateway for clients but still can not connect to internet.
Any Idea?