[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
[GUIDE] How to open ports for Remote Desktop RealVNC on TD-W8980
Region : Venezuela
Model : TD-W8980
Hardware Version : V1
Firmware Version : 0.6.0 1.5 v000e.0 Build 140408 Rel.49241n
ISP : CANTV
Hi, to open port to a specific application. we do a number of requirements:
. 1 - We must set the IP address of our PC with the corresponding MAC address in "DHCP Server > Address Reservation" and "IP & MAC Binding > Binding Settings".
. 2 - We know that port number and protocol the application uses, for that we use the tool NirSoft CurrPorts.
In my case, I'll open port 9594 on the application of remote access, RealVNC.
. 3 - We open the port "Forwarding > Virtual Server" and "Forwarding > Port Trigger".
Then try connecting remotely from another PC, SmartPhone or Tablet with the Viewer application.
Note: This guide can be used for other applications.
Model : TD-W8980
Hardware Version : V1
Firmware Version : 0.6.0 1.5 v000e.0 Build 140408 Rel.49241n
ISP : CANTV
Hi, to open port to a specific application. we do a number of requirements:
. 1 - We must set the IP address of our PC with the corresponding MAC address in "DHCP Server > Address Reservation" and "IP & MAC Binding > Binding Settings".
. 2 - We know that port number and protocol the application uses, for that we use the tool NirSoft CurrPorts.
In my case, I'll open port 9594 on the application of remote access, RealVNC.
. 3 - We open the port "Forwarding > Virtual Server" and "Forwarding > Port Trigger".
Then try connecting remotely from another PC, SmartPhone or Tablet with the Viewer application.
Note: This guide can be used for other applications.
