Td-w8980 in bridge mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Td-w8980 in bridge mode
Region : Argentina
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
Hi
Ive setup my new W8980 as a bridge as per this link http://www.tp-link.com/en/article/?faqid=447 but I've a problem with connecting with an Ethernet cable to the internet.
I have bridged to a Tg582n and can access the internet wirelessly through the W8980 without problems, but if I connect to the W8980 via Ethernet cable I cannot access the internet via that method. My intention was to connect to the W8980 via Ethernet cable and allow me to access the internet without running cables around the house.
advice would be much appreciated as I've spent days researching this and can not work out where I'm going wrong.
Model : TL-WDR4300
Hardware Version : V1
Firmware Version :
ISP :
Hi
Ive setup my new W8980 as a bridge as per this link http://www.tp-link.com/en/article/?faqid=447 but I've a problem with connecting with an Ethernet cable to the internet.
I have bridged to a Tg582n and can access the internet wirelessly through the W8980 without problems, but if I connect to the W8980 via Ethernet cable I cannot access the internet via that method. My intention was to connect to the W8980 via Ethernet cable and allow me to access the internet without running cables around the house.
advice would be much appreciated as I've spent days researching this and can not work out where I'm going wrong.
