How to use real IP adresses on LAN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to use real IP adresses on LAN
Region : UnitedKingdom
Model : TD-W8968
Hardware Version : V3
Firmware Version :
ISP : Eclipse
I'm trying to configure my TP-LINK TD-8968 so that I can use a few real IP addresses on my LAN but can't figure out how to do so....
The WAN interface uses the IP address I want on my LAN. How do I change this? Do I need to set up the device as a bridge?
Model : TD-W8968
Hardware Version : V3
Firmware Version :
ISP : Eclipse
I'm trying to configure my TP-LINK TD-8968 so that I can use a few real IP addresses on my LAN but can't figure out how to do so....
The WAN interface uses the IP address I want on my LAN. How do I change this? Do I need to set up the device as a bridge?
