TD W 9980 Firewall issue-help
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TD W 9980 Firewall issue-help
Region : Greece
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.6.0 1.6 v0021.0 Build 140613 Rel.50511n
ISP : OTENET
Hi, I am using TD9980 over VDSL2 and having a serious problem making the firewall work. I am using IPv4 firewall and want to enable certain IP adress to access internet in specific time period.I have followed the FAQ but still cannot make it work; this is what I did:
Reserved the IP address of the client-as permanent
Used LAN Host to create new entry based on allocated IP
Created Schedule where I marked the time slot I want to be enabled
Created Rule with Lan Host name, schedule and the following: Action : Allow, Direction: Out,protocol:ALL,WAN: Any WAN, Host the one I named before, Schedule:the one I name before
Finally Enabled Firewall and Allow Filtering rules and Save.
It does not work whatsover changes you make.
The rule is enabled while other rules are disabled.
Host is connected directly to Router and not via switch.
Tried to reboot the modem , still no result.
Any other suggestions? Would appreciate your prompt reply!
thank you
Model : TD-W8968
Hardware Version : V1
Firmware Version : 0.6.0 1.6 v0021.0 Build 140613 Rel.50511n
ISP : OTENET
Hi, I am using TD9980 over VDSL2 and having a serious problem making the firewall work. I am using IPv4 firewall and want to enable certain IP adress to access internet in specific time period.I have followed the FAQ but still cannot make it work; this is what I did:
Reserved the IP address of the client-as permanent
Used LAN Host to create new entry based on allocated IP
Created Schedule where I marked the time slot I want to be enabled
Created Rule with Lan Host name, schedule and the following: Action : Allow, Direction: Out,protocol:ALL,WAN: Any WAN, Host the one I named before, Schedule:the one I name before
Finally Enabled Firewall and Allow Filtering rules and Save.
It does not work whatsover changes you make.
The rule is enabled while other rules are disabled.
Host is connected directly to Router and not via switch.
Tried to reboot the modem , still no result.
Any other suggestions? Would appreciate your prompt reply!
thank you