TL-PA4010 Pair button doesn't seem to do anything

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-PA4010 Pair button doesn't seem to do anything

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-PA4010 Pair button doesn't seem to do anything
TL-PA4010 Pair button doesn't seem to do anything
2015-02-24 00:59:41
Region : Argentina

Model : TL-WPA281

Hardware Version : V1

Firmware Version :

ISP :


Hi,

I just picked up a TL-PA4010KIT and wanted to set up a private network. The pair of devices are working fine as is (i.e., the powerline network has been setup), but pushing the pair button on either of the 2 devices doesn't seem to do anything. According to the instructions, pushing the pair button for 1 second is supposed to cause the Power LED to begin flashing.

What am I doing wrong?

Thanks
Scott
  0      
  0      
#1
Options
1 Reply
Re:TL-PA4010 Pair button doesn't seem to do anything
2015-02-26 15:06:56
Plug the two units in a power extension cord or place them in the same room to try.
Actually, there is another way to set up a private network. You can rename the network using utility.
http://www.tp-link.com/en/article/?faqid=258
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 588

Replies: 1

Related Articles