Powering on TP Link Archer VR900 with no antennas connected
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Powering on TP Link Archer VR900 with no antennas connected
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello,
I recently purchased a VR900, it seems to be working well. However I didn't see much of an improvement if any against my old BT Home Hub 5 wireless - they seem on par.
I was wondering if its possible to damage or degrade the radio circuit if no antennas are connected as I ran the router at work for around 3 hours whilst configuring it before installing it in my home?
Thanks.
Hardware Version : Not Clear
Firmware Version :
ISP :
Hello,
I recently purchased a VR900, it seems to be working well. However I didn't see much of an improvement if any against my old BT Home Hub 5 wireless - they seem on par.
I was wondering if its possible to damage or degrade the radio circuit if no antennas are connected as I ran the router at work for around 3 hours whilst configuring it before installing it in my home?
Thanks.
