Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

Hi All
I just bought a Archer VR900 about 2 weeks back , got it all setup and connected to plusnet fibre broadband .
So first thing after i set it up ....i thought i would update the firmware to the latest one Archer_VR900_V1_151111
Well it rebooted but would not reconnect to the net .....so eventuall i rebooted it ....and it reconnected to net again after a bit of time.

Its been fine for 2 weeks ....until today when we had a power cut ....modem reconnect ...but dont know how long it took as was at work.
6pm tonight ...power went off again ...but will not reconnet to net ....tried rebooting and even factory reset but still no good.

Found my old BT homehub 5 out and that connected fine.

So next step i though i would flash back to the orginal firmware that router came with .. Archer_VR900_V1_150909
Router rebooted and connected to the net straight away ....so guessing the new firmware has issues.

Any one else had this ?
Have contacted TP Link abaout this issue too.

Karl