Configuring Bridge on WR720N
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuring Bridge on WR720N
Model :
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a WR740N serving my internet and I tried to configure my WR720N as a bridge. I followed all steps, enabling the WDS, discovering the SSID to bridge, adjusting the channel, adjusting the passkey, changing the LAN IP to 192.168.2.1 (My WR740N is 192.168.1.1) but, when I tried to disable the DHCP, the WR720N does not accept the change.
I already have updated the firmware on WR720N but the behaviour continues the same, I am not able to disable DHCP on my router.
Any idea? Should I replace my router to another model?
Thanks in advance
Leandro
Hardware Version :
Firmware Version :
ISP :
Hello,
I have a WR740N serving my internet and I tried to configure my WR720N as a bridge. I followed all steps, enabling the WDS, discovering the SSID to bridge, adjusting the channel, adjusting the passkey, changing the LAN IP to 192.168.2.1 (My WR740N is 192.168.1.1) but, when I tried to disable the DHCP, the WR720N does not accept the change.
I already have updated the firmware on WR720N but the behaviour continues the same, I am not able to disable DHCP on my router.
Any idea? Should I replace my router to another model?
Thanks in advance
Leandro