TP-WR802N Client mode
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-WR802N Client mode
Model :
Hardware Version :
Firmware Version :
ISP :
Hi
I am trying to setup the TP-WR802N in client mode.
I follow the instructions: connect to the router, choose "Client Mode", wait for scanning to finish.
At the end, instead of the tabel with available wireless netowrks, a blank page with an error message is displayed: "NETWORK CHANGE DETECTED".
There's nothing special with the WiFi network, just an usual home router (
What can I do?
Thank you.
Hardware Version :
Firmware Version :
ISP :
Hi
I am trying to setup the TP-WR802N in client mode.
I follow the instructions: connect to the router, choose "Client Mode", wait for scanning to finish.
At the end, instead of the tabel with available wireless netowrks, a blank page with an error message is displayed: "NETWORK CHANGE DETECTED".
There's nothing special with the WiFi network, just an usual home router (
What can I do?
Thank you.