davidecitLV1Online
Following: 0Followers: 0
Forums/ Deco
2024-03-15 23:20:12
Deco P9 In my basement
Hello, I have actually 3 P9 in my house (a standard home in apartement at first floor). Now I would like to add a 4th deco in my basement (so BELOW the other decos). Which setup option should I...
0HELPFULS
Forums/ Deco
2021-06-30 21:56:58
P9 +Powerline AV 1000 = NO PLC
Hello I recenly replaced M4R Deco with new Deco P9. The 2 Decos are connected via Wifi (just one wifi circle), but I can't see PLC that is the main reason I bought P9, because I have a little house...
0HELPFULS
Forums/ Deco
2021-06-23 23:42:18
Re:Copying settings from M4 to P9?
@Alexandre. I am not sure this is the correct way. As far as I know, it's better to start a brand new mesh when you make an hardware upgrade as this to let it adapt the line in the best way (p9 has...
0HELPFULS
Forums/ Deco
2021-06-23 20:59:10
Copying settings from M4 to P9?
Hello, I just bought P9 to replace my actual M4. I have few settings made in these months using M4 (name of the devices, some rules for the printer, etc). Is there a way to copy my actual settings in...
0HELPFULS
Forums/ Deco
2020-12-14 13:10:38
Re:Can't connect PC (ethernet) to the Wifi Printer
Thank you. After I switched to AP mode, I forgot to reset the connection on the printer. After that I set the static IP via Router ando not via Deco (like I previously done when it was on Router mode)
0HELPFULS
Forums/ Deco
2020-12-12 17:33:19
Can't connect PC (ethernet) to the Wifi Printer
Hello, I have a PC connected to the Router via ethernet, but I can't find the Wifi printer that is connected to a Deco via Wifi. I reserved a static IP on the Deco, but when I find it via Epson Scan...
0HELPFULS