I have a few simple devices, Hue, Hive etc that require an ethernet connection. Can I use one ot the connections on the rear of a nearby M4 wifi node to connect a hub / switch to allow connection of...

@TP-Link Thank you for replying. Currently my router is connected with the supplied ethernet cable to the first M4 and then wifi to the remaining nodes. My IP address is Dynamic. Thanks again

I've currently got the best mesh since installing my M4 system. Problem is I'm going to change supplier so will be getting a new router. Can someone remind me how to set it up again with a new...

@Alexandre. Sorted all good now thank you.

@Alexandre. Thank you very much for that answer it was very helpful, however one further quick question if I may? To follow your way of access as opposed to Router for the Deco, do I have to switch...

OK i have my M4s and am ready to go and install BUT before that I have a question. My router (supplied by ISP) can be set as a router or as just a modem. Currently it is in router mode and that's the...