Forums/
WiFi
2017-07-21 08:46:00
EAP controller adopts hang-side network, so it's just used to manage and monitor the EAPs in network. The EAP controller has no NAT and DHCP function, you can not use it as a router to receive the...
0HELPFULS
Forums/
WiFi
2017-07-20 17:23:28
Theoretically, one EAP330/320 is usually recommended to connect 25~30 clients for each band (2.4GHz and 5GHz), while the real connections depends, you need to consider 3 factors below: 1. Due to the...
0HELPFULS
Forums/
WiFi
2017-07-20 17:02:52
If you want to use comcast modem as bridge, then I think you have to buy an extra NAT router. While since TL-R480T+ adopts fast Ethernet port, and its NAT throughput is within 100Mbps, so it might...
0HELPFULS
Forums/
WiFi
2017-07-17 14:14:51
I have been able to access the management interface and update the settings via the EAP's WiFi network but am unable to obtain an IP address from the device, Not very clear, do you mean the wireless...
0HELPFULS
Forums/
WiFi
2017-07-17 14:00:52
When you lose Internet access, can your wireless clients still obtain a normal IP, and you can try to ping AP, gateway, 8.8.8.8 to see whether it's accessible? And how about the wired connection, if...
0HELPFULS
Forums/
WiFi
2017-07-17 11:13:24
In normal cases, the recommended client number is around 25~30 per band, including 2.4GHz band and 5GHz band. While the real supported connections also depend on your clients' networking behavious.
0HELPFULS