KRowland wrote On a Gigabit network, copying files using SAMBA (Windows SMB) I get about 180-220 mbps. Higher than 100mbps ethernet, but nowhere near the gigabit (1000mbps) speeds. I ran another...

For me, when trying to use two routers to extend coverage I always recommend the following: Setup the first router connected to the Internet source as you would normally, defaults, NAT on, DNS on,...

Yes, the limiting speed will be the lower spec of any two of the wifi devices. Testing with file transfers is also misleading, as the throughput of the software protocols and hard drive access speed...

Leave your Mac in DCHP mode. The stock router should give you a first time IP address of 192.168.0.100. Then you go to http://192.168.0.1 and login with admin / admin.

Reference the other thread..... Ah yes! Bridge mode avoids ICS problems and just couples the ethernet port to the same network as the Wifi adapter. Nice. I'll have to remember that, as I don't use...

I have posted elsewhere that I used a 702 Nano router as the client to get the local wifi signal and then directly plug that into a TP-Link 3600 router WAN port and then connect all my devices to it,...