partition fs-uboot base 0x00000 size 0x20000 partition partition-table base 0x20000 size 0x02000 partition default-mac base 0x30000 size 0x00020 partition product-info base 0x31100 size 0x00100...

You are right, you can get the cable to flash the spi without desolder it, the software comes with the programmer, you can edit the dump in a hex editor then flash itAny progrmmer would work that you...

well what did is just remove the spi flash from the ap the image of the chip is in the other thread , read and save the current image on the chip, then with a hex editor copy a openwrt sysupgrade fw...

i would be gladful if anyone uploads a pharos flash dump, cpe510 is the same as cpe210

i have successfully fixed my router , still with bad recovery, but what i have done is reading my old dumb and write the os at the right address which is 40000 and that was it for me, so i guess if...

the boot loader didnt work i get the same output as the old bootloader, i have v1.1 dose it make any difference, i used your image and flashed it on the spi flash using usb programmer, i get this...