Yeah that was a challenge in my environment as well, once I've set the ports to 1000 I could get a connection and add them to my controller, but then they revert back to 10g and lose contact with the...

@KJK got it, my switch is not yet supported by device cli configuration, I'll have to test this after a firmware upgrade. thanks again!

@KJK That makes sense, previous output shows NAS end with priority of 255 while switch is defaulting to 32768 i've found this how-to https://www.tp-link.com/us/support/faq/991/ but that applies to...

@KJK Thanks, I did some further testing like yourself and found that none of the 6 hashing algorithms provide 2gbit when going to wired clients, however when piling on wireless clients i'm getting...

Thanks @KJK and @Insomnic I understand that traffic between PC1 and NAS will be limited to 1Gbit, the point is that under no LACP or Static LAG settings am i able to break past the 1Gbit barrier...

Hello, New Omada user here, having an issue with TL-SG2008P and my Synology NAS with LACP. My switch is managed by an OC200, LAG1 LACP enabled: From Synology's end, LACP is enabled and both ports...