Thanks, Joseph I already chatted with the support about my issue and, after some trial and error, i can say i resolved. I basically reproduced some steps like @NivaIR without the firmware part....

I contacted the support where they basically responded me with a standard reply about the conf. of easymesh ethernet backhaul. this is what i replied back: Hello, basically i re-did the configuration...

Tried again right now: When pluggin the eth cable : And unplugged right after: .

Hello there, i was searching for previous similar issues to mine and i stumpled upon this thread. The thing that is the same as your is that my AX53(but V2) seems misbehaving with my other AX55v1 My...

is there any ETA on this subject?

So i have to find another of doing it in the router. but i dont know how. Even if i block certain MAC's it wil not only prevent to connect to the wifi but also block the internet