Hi @RobPham Regarding the EasyMesh Ethernet backhaul node dropping speeds to 100mbps, I have found the issue as to why mine drops to 100mbps. My issue was my Ethernet cable are exposed to the sun...

Hi @Kevin_Z Will there be a pre-release firmware for the AX80 US model as well?

Hi @zexoni70 I could give you a clear answer since I have tried and have experienced two of the scenarios you described. 1. The satellite will keep it's settings and you won't have to repeat the...

@zexoni70 Yes EasyMesh does work. Plugging ethernet cable back into the satellite with the workaround does make it work with EasyMesh. But the steps to make the channel and channel width propagate...

Hi @zexoni70 I’m not sure if you had a look at the workaround I posted which is on the bottom of page 4 on this thread, but the channel and channel width not propagating seems to be only on wired...

@RobPham Yes I have. I unplugged the ethernet cable, power off the router/satellite, plug the ethernet cable back in and power on the satellite to get it back to 1000mbps. I’m not sure what causes...