I've now fully tested our ISP connection, bypassing our TP-Link Deco BE65 Pro v1.0 running 1.2.0 firmware, and plugging my laptop directly into the Network Termination Device (NTD) and doing both...

David-TP wrote I'll report the firewall setting issue to the engineers to see if they can reproduce this issue on their end. "Get IPV6 Address" is set to "Auto" by default. It is compatible with both...

Just logged into the ISP portal and it lists both the /64 and /48 that was requested and replied to for each connection session. 2400:a844:x:x::/64 2400:a844:x::/48 It only shows the last 10...

Sorry in advanced about quoting but I couldn't get single sentences to only quote. > Hi, may I know your internet service provider? leaptel.com.au > Deco IPV6 configuration page is a simplified...

HelpFixDecoApp wrote @evilbunny A few other trouble shooting steps you can try while we wait for David If your Deco system is configured for DHCPv6 on the WAN port and the Deco app isn't showing the...

HelpFixDecoApp wrote @evilbunny and let us know which example best describes how your network is set up None of them, because the internet provider has installed a 4 port Network Termination Device,...