@Kevin_Z Finally getting around to replying, I can't be 100% sure of the timing but I had shut of the 6G network temporarily to see if roaming was cleaner without. I had the 6G set up with the same...

@Kevin_Z I must have jinxed something. My phone's notifications started going off over and over again and it was Tether. All client were rejoining the network. I noticed that nothing was connecting...

@Kevin_Z Providing an update: So far I have not run into any issues after updating to the latest beta firmware and swapping the two devices. Client names are transferring properly between both...

Kevin_Z wrote Kevin_Z wrote @rm1091 Thanks for getting back. To conclude, there are three issues with two BE550s connected via EasyMesh Ethernet Backhaul: 1. The IoT device names cannot be...

Kevin_Z wrote rm1091 wrote @Naebun apologies I was not keeping tabs on this thread recently. I had not attempted to adjust the width previously but I can get some testing in there. I was hoping to...

@Naebun apologies I was not keeping tabs on this thread recently. I had not attempted to adjust the width previously but I can get some testing in there. I was hoping to have found stability but...