yandoo wrote I don't have that options. My problem was caused by too many networks around me and after a talk with my neighbors we agreed to set different channels. It still happens sometimes but it...

30 to 40 dB SNR is a rather good value in an overcrowded 2.4 GHz band. Note that a lot of consumer devices make use of this band, not only WiFi gear.

TX/RX rates for wireless frames are constantly changing depending on the data being transferred, but this is not related to data throughput. If the link is idle, WiFi rate drops. TX/RX just show you,...

Yes, there is much confusion about this. AFAIK CPE510 UN v1.1 hardware supported test mode (I have two of them), while CPE210 EU v1.1 does not or at least not always. But this restriction is not...

manghy wrote How can I do this as like older TL-WA5210G device ???? Just disable the AP mode in the Wireless menu. It will still allow use of the WiFi interface in STA mode to connect the CPE to your...

yandoo wrote Get firmware 2.0.0 and on initial setup select Test Mode in Country Does not work either on v1.1 hardware. TP-Link removed test mode starting with this hardware version. It's hard-coded...