Kolobo4egggg wrote Do you have any suggestions on pointing outdoor eaps antenas? Now i made same 90 degree low and point it each to other. The antennas of an EAP-Outdoor should stand upright parallel...

JonathanSK wrote Questions: 1) Should I use maxstream between the AP and Client 2) I going to put an AC1200 on the same wall as the CPE510 AP. Is there a minimum distance away I should put the...

Boriy wrote We're planning to use Cat 6A, since it has 10Gb transfer rate and 100meters performance distance. Which means in future, we do not need to upgrade cables only devices. Can Cat 6A still...

@Klic, clear the list of known SSIDs on at least those clients which insist to connect to UBNT APs. It's always the client device which decides to which BSSID to connect to for a specific ESSID (aka...

JonathanSK wrote I have a 100FT Shielded Cat 6 cable that I'm running from outside the building to the POE inside the building and then a short Cat 6 LAN to the switch. Cable looks ok, albeit I...

JonathanSK wrote I'm going to set it to a static IP. Reserve that IP on the Router. Test. And then setup the Client by setting it to a static IP, reserving it on the router, and also locking it to...