@Dean95 As you wrote TL-SG1024 is an unmanaged switch. It doesn't have any SSH, TELNET, DIRECT or WEBUI access as such nor IP address - it's a plug'n'play device, i.e. no configuration needed. You...

@rockkuh Refer to this thread regarding your issue.

@Shihab8122 Here's the support page for C54 and its latest FW release.

@lorenz29 The correct model of your router is on its bottom sticker - details. There were succewssful attempts by users to setup wireless backhaul mesh between Onemesh main router and Easymesh...

@Ed28 Check your C24 bottom sticker and make sure that you are using the correct FW region - details. If you use a FW file for a different region an error message like this could pop up.

@Palunko This is the guide for configuring a RE in AP mode. RE200 v1 might not have this mode implemented since its latest FW is too old.