@deejerydoo You can use the FW release for v2.1 - here. It shuld be the same as for v2. Vx.0=Vx.6/Vx.8/Vx.9(eg:V1.0=V1.6/V1.8/V1.9) Vx.x0=Vx.x6/Vx.x8/Vx.x9 (eg:V1.20=V1.26/V1.28/V1.29)...

@Modarlink The Dish V4 is paired with an equally new and improved Gen 3 Router According to its specifications Starlink Gen 3 router has the following parameters: Starlink Wifi Router Product...

@jolondon Did you follow these instructions for Starlink gen 2 ? They are quite straight-forward. The problem may have been caused by the AC1200 configuration - reset the AC1200 to its factory...

@mnewiraq The answer to your question would be pretty much similar to this one. Archer AX23 V1.20 and V1 are sharing the same firmware release.

@Vixh0 If that's the case then perhaps on your main router you can use a device isolation feature or similar to isolate the C80. Other than that, if you swap the location of your home network to be...

@Vixh0 You should use the C80 in roter mode if you want to isolate its guest wireless network from its main wireless network: Allow guest to access your local network should be unchecked: