@Skyecairn If you've changed your main router you should reset the RE to its factory defaults and re-configure from scratch. To reset the RE press its reset button for about 10 seconds.

@Frank-Luffy_64 This should be possible since your EAP is just a bridge between your main router and the RE.

@Scultura Your Archer AX23V is for the local market in Japan - here you can download and update its FW release v1.0.3 (published on 19.12.2024). Update the AX32V FW and make a test in AP mode. I...

@Spawn_e_git "Ideally TP-Link would produce an EasyMesh compatibe device that can be located oustide...". AFAIK AX1800 is not with a detachable antennas and it would be difficult to use SMA extension...

@loughside A lightnning storm theoretically can harm VR400 via its DSL or ethernet ports as well, but fibre cable cut shouldn't have caused any harm to this device. How did you test the ethernet port...

@loughside Downed power lines can cause power outages. Before the power goes out, though, voltage along power lines often fluctuates wildly, which causes dangerous power surges. When larger...