Home Network Community5G/4G RoutersI need Manual Band Selection for MR200 v2
5G/4G Routers

I need Manual Band Selection for MR200 v2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I need Manual Band Selection for MR200 v2

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I need Manual Band Selection for MR200 v2
I need Manual Band Selection for MR200 v2
2022-05-06 00:49:16 - last edited 2022-05-06 00:53:42
Model: Archer MR200  
Hardware Version: V2
Firmware Version: 1.2.0.0 9.1 V004a.0

Hi my MR router not get internet some time.  There is no range iissue.  Possible to get manual band selection firmware 

  0      
0
#1
Options
1 Reply
Re:I need Manual Band Selection for MR200 v2
2022-05-07 06:15:28

  @Tp-fanboy 

Hi, Sorry for that MR200 V2 doesn't support to select 4G band manually.

For the no internet issue sometimes, may I know if it recovers automatically or you have to reboot the router? 

Please insert the same SIM card into another 4G device if possible to test the stability, if only the MR200 V2 has the unstable issue, please provide status page and system log file when problem happens.

 

By the way, if it falls back to 3G sometimes when 4G has a good signal, you could also try to change Network Type from 4G Preferred to 4G only.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
0
#2
Options

Information

Helpful: 0

Views: 1234

Replies: 1