TP-Link WR802N cannot connect
Even if I connect it to the device's interface with a cable, I cannot log in. The default password is deleted on the device label, so I cannot log in. Is there an algorithm for the default password or a way to solve it? I have almost 60-70 of them, on average, most of them are like this and I cannot log in.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
It may depend on how old the firmware on the particular TL-WR802N is.
With old firmware that asks you to input a username and password the default will be admin for both. If the username and/or password have been changed by someone, then a factory reset should restore the default.
Newer firmware that only asks for a password has no default password. When used for the first time or after a factory reset the user will be asked to set a new password before being logged in.
Anyway, it seems the key for you to get into the device is to perform a factory reset by pressing and holding the small "Reset" button for about 5 seconds.
- Copy Link
- Report Inappropriate Content
Hi,
It may depend on how old the firmware on the particular TL-WR802N is.
With old firmware that asks you to input a username and password the default will be admin for both. If the username and/or password have been changed by someone, then a factory reset should restore the default.
Newer firmware that only asks for a password has no default password. When used for the first time or after a factory reset the user will be asked to set a new password before being logged in.
Anyway, it seems the key for you to get into the device is to perform a factory reset by pressing and holding the small "Reset" button for about 5 seconds.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 85
Replies: 1
Voters 0
No one has voted for it yet.