I’m managing my network with an OC200 + ER7206 + Managed Switch setup.

My goal is to access and manage a ZTE router (IP: 10.10.10.254) located in VLAN 10 (subnet 10.10.10.0/24) from my Admin LAN (192.168.0.0/24).

Here’s my configuration summary:

Gateway: ER7206 (managed by OC200)

Admin VLAN (Default): 192.168.0.0/24

LAN_OLD_Switch (VLAN 10): 10.10.10.0/24

ZTE Router: Static IP 10.10.10.254 (DHCP Off)

Controller: OC200

ACL: Permit Admin → VLAN 10 (LAN→LAN rule)

Static Route Attempt: Tried 10.10.10.254/32 → Admin (Default) but no result

Currently, I can reach VLAN 10 devices only if my PC is manually set to the 10.10.10.x subnet.

Ping from 192.168.0.x → 10.10.10.254 returns “Destination host unreachable” from 192.168.0.1.

What I need help with:

Confirm the correct way to enable inter-VLAN routing in the OC200 interface or directly on the ER7206 (new firmware hides the toggle).

Verify if any additional static routes or ACL rules are required.

Ensure that this setup allows Admin LAN devices to reach 10.10.10.254 without breaking VLAN isolation.

Any advice or screenshots from a similar configuration would be appreciated!

Hardware / Versions:

TP-Link ER7206 v1.x

OC200 Controller (Omada SDN 5.x)

Managed Switch with Port 24 as Access VLAN 10

ZTE F670L connected via Easy-Manage Switch