Current configuration:
SFP1 WAN
SFP2 Uplink to 10G Aggregation Switch
All other ports disabled.
After reboot, SFP3 LED lights up, even though the port is disabled and nothing is connected (not even an SFP module is installed). The only way to get the LED to turn off is to turn the port on, then back off. LED then turns off and stays off.
Can this issue be reproduced consistently? Do ports other than SFP3 exhibit the same behavior? Does it only appear after a reboot, or does it never occur under normal conditions? We haven’t received similar reports before; the LED-indicator symptom looks like a possible hardware defect. If you’re concerned, please contact support to arrange a replacement.
Can this issue be reproduced consistently? Do ports other than SFP3 exhibit the same behavior? Does it only appear after a reboot, or does it never occur under normal conditions? We haven’t received similar reports before; the LED-indicator symptom looks like a possible hardware defect. If you’re concerned, please contact support to arrange a replacement.
@Ethan-TP Yes it can be reproduced consistently. No other LEDs have the same issue. I didn't even notice right away because I would assume all LEDs operate correctly. I don't believe it is a hardware issue, but maybe it is.
Helpful: 0
Views: 73
Replies: 2
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
