Controllers
TP-Link Omada Cloud SDN integrates Omada Devices including EAPs, JetStream Switches and Omada Routers, all are centrally managed with an Omada SDN Controller. Anything related to TP-Link's Omada SDN Controller, welcome to ask questions, join discussions and share your experience/knowledge here.
Controllers
Hi, Wi-Fi 7 Global Launch Event Discussion! TP-Link is joining our global partners in putting on a launch event explaining how we plan to bring the latest in wireless communications to our brands and
Highlighted ThreadOfficialWi-Fi 7
By
Hank21
Hank210Helpful
260Views
Hi I am currentry tying to setup a dedicated voice network. I have an ER605 router, two SG2008P switches and one Gigaset Go-Box 100 connected to one of the switch ports. I also have set a dedicated VL
Voip
2Helpful
318Views
I noticed in Omada Controller there are options for Port Forwarding and related controls, however they all prompt that a Gateway is required. I am assuming it is looking for a Omada Compatible Gateway
By
RickJamesBish
· Latest post 2022-11-15 17:08:49 by
Philbert
1Helpful
348Views
As the subject says... After loading the latest firmware, all the widget layout locations were changed.., editing the layout and moving everything to where I want it works, until I log out and log bac
0Helpful
536Views
So in create a new group, you can make: ip group ip:port group mac group but you can't select mac group on EAP ACL group sets ? why is this ? I know there are devices which can 'fake mac' but on some
0Helpful
209Views
Router 605 with USB for 4G modems. It ONLY has the USB modem, no other WAN. Only the USB Modem port is active, other WAN ports unchecked. When trying to add any VPN, ( IPSec, PPP, L2TP, server/client,
4G modem
0Helpful
279Views
This Article Applies to: Omada_Software Controller_v5.6.3 Supported OS: Windows or Linux (64 bits recommended) Release Notes: New Feature/Enhancement 1. Added the following features to Omada Gateway,
Firmware UpdateOfficial
13Helpful
4010Views
It seems that AI WLAN Optimization only works on non DFS channel, when channel limit is enabled it fails. if we are to have this function, DFS channels must also be included, otherwise it is meaningle
1Helpful
3377Views
I have 3 sites. Each with its own software controller. Goal: have ONE soft controller. Have all remote sites connect and use that one controller. I have followed to a T these instructions: https://www
Adoptioncontroller
0Helpful
435Views
Hello, I keep getting the following messages in my OC200 logs: Loop was cleared on [osw:TL-SG3428:00-5F-xx-xx-xx-xx]'s port Gi1/0/5. or T1600G-28TS port Gi1/0/24 was blocked. Can someone explain me th
By
lukass2000
· Latest post 2022-11-11 18:50:33 by
lukass2000
4Helpful
2039Views