General Discussion
Latest scandal with Ubiquiti storing passwords on last pass without any additional security like 2FA leaves a lot of questions. Back then some time ago, when a thread about what to buy was created, mo
0Helpful
387Views
OK, so here is my situation. I have a basic setup using the ER605, OC200, a new switch coming in this week SG2008P (currently using SG1008P), I have one EAP245 and one EAP670, I actually just upgraded
0Helpful
370Views
I have a specific question regarding improving the way tp-link routers and controllers would control attached access points to mesh networks over wired or wifi mesh. The point of this thread is that T
0Helpful
692Views
Hi, I am just wondering whether if there is a switch, router or modem available here that could take a WAN internet output from a CPE 710 and output it to a LAN port which supports 802.3ad for WAN agg
802.3ad
2Helpful
300Views
Hello all. I've decided to take on the task on learning to set up a network and have some questions. First, background. Currently my network has 2 sites, my home and a vacation home. They are connecte
2Helpful
294Views
Hello, What do you think would work better for the warehouse diagram below? My options are 1. Use 3x CPE710 or -- Yellow Triangle 2. Use 6x EAP620 or EAP245 -- Green Circle Or what would you recommend
2Helpful
296Views
Hello folks- I have been using TP-Link products for awhile and have a basic knowledge of setting up Omada products in the small buisness environment, for instance I have one place set up with 2 indoor
By
Piamus
· Latest post 2022-09-02 09:50:59
by franklin1122
0Helpful
319Views
I have three sites, each with a small network. The three are then interconnected using IPSec VPN tunnels. The primary site is my house. The other two sites are a second house (hundreds of miles away)
By
PeteT
· Latest post 2022-08-29 16:00:03
by Roxana1122
0Helpful
419Views
Hi all, I have a main router with internet connection, i've added another router with the same model as with Access Point mode, i need to disable the second router (access point mode) from getting int
0Helpful
315Views