Archer VR900 - SNMP Implementation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer VR900 - SNMP Implementation

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer VR900 - SNMP Implementation
Archer VR900 - SNMP Implementation
2020-07-08 10:23:45 - last edited 2020-07-09 01:59:49
Model: Archer VR900  
Hardware Version: V3
Firmware Version: 0.5.0 0.9.1 v0069.0 Build 200624 Beta.68497n

Hi,

 

Although the VR900 supports snmp it doesnt appear to support standard mibs , I am using Zabbix to monitor the traffic and it does not find any of the gigabit ports instead it only finds

bcmsw, br0, ppp1 and ptm0.101

 

Additionally it reports them as being 100Mbps.

 

Am I missing some mib's or does the VR900 not fully support snmp ?

 

Regards

  0      
  0      
#1
Options
1 Reply
Re:Archer VR900 - SNMP Implementation
2020-07-29 21:30:14

Hi @GoKiwi 

 

I have the same issue with Archver VR400 and cacti. The answer to the standar mib is "Unknown", as you can see


SNMP: v2: 192.168.30.1, dsname: traffic_in, oid: .1.3.6.1.2.1.31.1.1.1.6.29, value: U
SNMP: v2: 192.168.30.1, dsname: traffic_out, oid: .1.3.6.1.2.1.31.1.1.1.10.28, value: U
SNMP: v2: 192.168.30.1, dsname: traffic_in, oid: .1.3.6.1.2.1.31.1.1.1.6.28, value: U
SNMP: v2: 192.168.30.1, dsname: traffic_out, oid: .1.3.6.1.2.1.31.1.1.1.10.15, value: U
SNMP: v2: 192.168.30.1, dsname: traffic_in, oid: .1.3.6.1.2.1.31.1.1.1.6.15, value: U

 

I haven't found yet any manual or documentation about MIBs or OID for this device. Its a pity.

I'll trying a bit before give up.

Regards.

  0  
  0  
#2
Options