Access point mode in Archer C50, AC1200, V2 (2 antennas)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Access point mode in Archer C50, AC1200, V2 (2 antennas)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

HowardBannister

2020-10-27 23:56:35 - last edited 2020-10-28 08:16:31

Posts: 28

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2019-01-23

Access point mode in Archer C50, AC1200, V2 (2 antennas)

2020-10-27 23:56:35 - last edited 2020-10-28 08:16:31

Model: Archer C50

Hardware Version: V2

Firmware Version:

Good day,

Is there a way to set this router to "access point" mode? I checked all the settings - I do not see one that says "operation mode".

I tried disabling the DHCP, but the ipconfig command shows the assigned IP address as 192.168.0.xxx (i.e. assigned by the Archer C50) rather than 192.168.1.xxx (from the address pool coming from the ISP's modem/router).

The help will be greatly appreciated.

Thank you!

1 Accepted Solution

Kevin_Z

2020-10-28 08:16:27 - last edited 2020-10-28 08:16:31

Posts: 21618

Helpful: 5059

Solutions: 2550

Stories: 21

Registered: 2018-12-24

Re:Access point mode in Archer C50, AC1200, V2 (2 antennas)-Solution

2020-10-28 08:16:27 - last edited 2020-10-28 08:16:31

@HowardBannister

Hello, thanks for asking.

There is no Access Point mode on the Archer C50 V2, while you can configure it into an access point manually as below:

https://www.tp-link.com/support/faq/1199/

Hope this helps.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Access point mode in Archer C50, AC1200, V2 (2 antennas)

Access point mode in Archer C50, AC1200, V2 (2 antennas)

Information

Voters 1

Tags