Eap225 not adopt remote controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hi all, i have a problem with 2 eap 225....i am on my client and i cannot adopt eap on my controller that find on my office....i have also cloud but not resolve....it's possible help me?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hey
Did you mention the controller in the office.. are the EAPs in a different location? If so you need to have connectivity to the office to allow adoption, this can be via a VLAN or tunnel between the office router and the remote router where the EAPs are located
- Copy Link
- Report Inappropriate Content
yes my friends.... i speak about...
i am at your home and you have a eap 225 outdoor.... i have a controller to my office and i want add your eap 225 for management on my controller. i used discovery tool and insert when adopting:
Ip static of my office
login and password of eap
the message is adotped success, but i don't find on my controller.
i wrong?
i wait your helpm and greatfully
- Copy Link
- Report Inappropriate Content
What is your Controller version? What is the firmware version of your EAP? Please make sure it's not a compatible problem.
Moreover, you have to set port forwarding for your Controller, on your Router/Modem Router which the Controller is connecting to, open TCP&UDP port for your Controller, ranging from 29810 to 29813.
For your reference, here is the Guide,
- Copy Link
- Report Inappropriate Content
my controller is 3.2.14, and firmware on eap 225 outdoor is v1...it's possible??? i cannot resolve? i have open port of omada controller and i access from remote to my controller, but when i am to client i cannot add eap....only local
- Copy Link
- Report Inappropriate Content
V1 is the hardware version, not the firmware, and if the Controller is V3.2.14, the firmware or your EAP should be 
and you can also try to disable the firewall on PC for a test.
- Copy Link
- Report Inappropriate Content
Dear @Andrew71,
Andrew71 wrote
my controller is 3.2.14, and firmware on eap 225 outdoor is v1...it's possible??? i cannot resolve? i have open port of omada controller and i access from remote to my controller, but when i am to client i cannot add eap....only local
Kind note that the current EAP225-Outdoor firmware listed on the TP-Link website is almost for Omada Controller V4 or above.
To fully work with Omada Controller v3.2.14, you may check the firmware version(the Build number) of your EAP225-Outdoor, which can be found via the discovery utility. If the current firmware is compatible with Controller v4 or above, you may refer to this post to downgrade the firmware of your EAP225-Outdoor and see if it helps.
If your concern is resolved, I'd encourage you to give feedback to the community so others can be confident of the solution.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1137
Replies: 6
Voters 0
No one has voted for it yet.