Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > Block client from Archer AX90 configured in AP Mode

< Wi-Fi Routers

Block client from Archer AX90 configured in AP Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Block client from Archer AX90 configured in AP Mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cattalins

2022-07-29 01:39:27 - last edited 2022-08-01 02:44:53

Posts: 14

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-07-29

Block client from Archer AX90 configured in AP Mode

2022-07-29 01:39:27 - last edited 2022-08-01 02:44:53

Tags: #Access Point Mode #Feature Request #Roaming

Model: Archer AX90

Hardware Version: V1

Firmware Version: 1.1.8 Build 20220321

Archer AX90 allows the network admin to block certain clients to access the network, only when configured in Router Mode

When configured in AP Mode, you cannot blacklist a client from an antenna.

I have Tapo cameras that sometimes will roam to distant AP (15 meters away), and not roam back to the closest one and strongest signal (1 meter away, in the same room).

I would like to blacklist these cameras from connecting in the farthest AP.

1 Reply

terziyski

LV7

2022-07-29 10:54:32 - last edited 2022-07-29 14:42:17

Posts: 6971

Helpful: 5187

Solutions: 1126

Stories: 7

Registered: 2013-10-12

Re:Block client from Archer AX90 configured in AP Mode

2022-07-29 10:54:32 - last edited 2022-07-29 14:42:17

@Cattalins

You're in a complicated situation for those two reasons:

1. You're not using the AX90 DHCP server in 'wireless router mode'.

2. When in 'AP mode' some of the device features (like Access Control) are not available - see the details here.

I would enable AX90 DHCP server to add the Tapo cameras in AX90 Access Control => Black List and then disable AX90 DHCP server again.

During this procedure disconnect/disable your main DHCP server to avoid any messy network behavior.

Then check if this method will workaround your issue.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".

Block client from Archer AX90 configured in AP Mode

Block client from Archer AX90 configured in AP Mode

Information

Voters 0

Tags