Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0
Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0
2023-03-02 18:51:53
Model: TL-SG3210XHP-M2  
Hardware Version: V2
Firmware Version: 2.0.0 Build 20220322 Rel.62255

Hi Guys,

 

I am unable to get my ACLs working on the mentioned model I have tried from denying a simple ping to advance MAC ACLs but to no avail.

 

I have tried following the CLI and GUI guides but I don't know what I am missing here. Could this be a bug or an issue related to the firmware?

 

Regards,

Syed

  0      
  0      
#1
Options
3 Reply
Re:Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0
2023-03-07 21:15:15

  @xxxaidi 

 

Could you tell us what you are trying to accomplish on the ACL and perhaps put a few screenshots on here?   Is the switch managed (by a controller) or standalone?

 

It could be a number of reasons for the ACL not working

  0  
  0  
#2
Options
Re:Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0
2023-03-09 10:35:10

  @Philbert Hi,

 

So the switch is standalone and not being managed by a controller. The setup is basic and I have been trying to figure out whether the switch would support L2 ACLs which are port ACLs meaning that interface is not a L3 routed port and I have assigned a static IP on default VLAN. Just wondering if perhaps its a config issue or ACLs on L2 interfaces are not supported altogether.

  0  
  0  
#3
Options
Re:Unable to get ACLs to work on TL-SG3210XHP-M2 2.0 2.0
2023-04-01 06:55:44

  @xxxaidi I think you should check to see if you've put in the right firmware version. You might also try to reset your device to factory settings and then set up the ACLs again. If you still can't figure out how to set it up, call the support team so they can assist you figure out what's wrong. 

  0  
  0  
#4
Options