ER605 v2.0 - Port Forwarding with load balancing not working after upgrade to 2.1.1 and 2.1.2
ER605 v2.0 - Port Forwarding with load balancing not working after upgrade to 2.1.1 and 2.1.2
Hi, I'm having issues with Port Forwarding with load balancing on ER605 with omada controller.
I have two internet providers, one connect to wan and another to wan/lan1. I use to acess some internal services with Port Forwarding through wan/lan1
Both port are online and balancing is woking fine
To set this configuration I create the rule below
and policy routing to force redirection to wan/lan1 from those ips
internal IP -> IpGroup_Any
Internal IP + Port to IPGroup_any
Everything was working fine, but after upgrade to 2.1.1 when a tried to connect, I have a lot of packages that stay on pending and never got a responde from server inside network. It Seems that those packages are been forwarded to wan instead of wan/lan1. Upgrade to 2.1.2 didn't change this behaviour. If i disable balance and use only one wan everything works fine again
I'm using omada controller to set the config to the ER605
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@lemaoCool Hello, .I have ER605 for few days but I am still not able to make my port forwarding.
I have my virtual server entry. I want to froward incoming traffic from internet to WAN port 1005 to be forwarded to my inernal IP address port 3389, remote desktop. When I tried to connect nothing happen and also there isn't any information in log. Is there anything more I have to do? I am on last beta firmware 2.1.4 at this moment but I tried also 2.1.2 and older.
Thanks
D.
- Copy Link
- Report Inappropriate Content
Hi @DAVID_DAFA
Thanks for posting in our business forum.
You can refer to this link and troubleshoot it yourself first. I am sure that the port forwarding is working. If yours does not on various firmware, very likely to be a problem with your setup or network scheme.
Troubleshooting Virtual Services on the Router Doesn't Take Effect
- Copy Link
- Report Inappropriate Content
Hi, thanks for your reply. I just downgraded to official, not beta, version 2.1.2. We have a public IP on WAN, no load balancicng:
and only one virtual server rule to forward port 1005 to 3389.
Is there any other rule, like firewall, policy routing and other, to make it funcional?
Thanks
David
- Copy Link
- Report Inappropriate Content
Hi @DAVID_DAFA
Thanks for posting in our business forum.
DAVID_DAFA wrote
Hi, thanks for your reply. I just downgraded to official, not beta, version 2.1.2. We have a public IP on WAN, no load balancicng:
and only one virtual server rule to forward port 1005 to 3389.
Is there any other rule, like firewall, policy routing and other, to make it funcional?
Thanks
David
There is no other rule that should be implemented.
So, in that troubleshooting article, what are the results for each step listed?
Especially the telnet in LAN, do you have access to the port?
Have you contacted your ISP?
Recommend you update to beta 2.1.4.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2699
Replies: 14
Voters 0
No one has voted for it yet.