Home Network Community > 5G/4G Wi-Fi Routers/MiFi > how can i use my Archer MR200 as an access point from my existing broadband router
< 5G/4G Wi-Fi Routers/MiFi

how can i use my Archer MR200 as an access point from my existing broadband router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

how can i use my Archer MR200 as an access point from my existing broadband router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
how can i use my Archer MR200 as an access point from my existing broadband router
how can i use my Archer MR200 as an access point from my existing broadband router
2023-12-13 16:33:48
Model: Archer MR200  
Hardware Version:
Firmware Version:

Is it possible to use this MR200 as an extended access point from my existing broadband router

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:how can i use my Archer MR200 as an access point from my existing broadband router
2023-12-14 06:54:23

  @Chic0203 

 

Hi, there is no access point mode but you could configure it as an AP manually by following the Case 2 in this guide:

How to configure the TP-Link wireless router as Access Point

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:how can i use my Archer MR200 as an access point from my existing broadband router
2023-12-21 14:04:46

Keep in mind that the Archer MR200 may not have the same features as dedicated access points, so the range and performance may not be as robust. Additionally, if the Archer MR200 has a mode specifically designed for acting as an access point or bridge, you might want to check the user manual or contact the manufacturer for guidance on using it in that mode.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1442

Replies: 2

Related Articles
 Archer MR200: Access to LTE WAN I/F 'IP Address'
699 1
Using MR200 as ethernet only wireless access point.
4571 0
subnets in Archer MR200
858 0
ac1200 to archer mr200
795 0
What about Archer MR200(EU)_V4_20190730
2330 1
Use Extender as an Access Point
1736 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.