Archer AX53 in AP mode no connection on random devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I have the following problem with my home network. This is my topology:
The problem is the following: Router B is configured in AP mode with the cable coming from the switch modem connected to a LAN port (not WAN as specified in the guide). I've disabled the router's DHCP server and configured it with a static IP address on the main router's subnet. The default gateway and DNS IPs are matching the IP of the main router. Some devices connected to router B don't have access to the internet and some do, they are random and this happens sporadically. What have I done wrong?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
In AP mode DHCP should be disabled (refer the guide I posted).
Leave them to get their IP address dynamically (by your ISP modem/router DHCP server).
Test the internet connectivity and most important - test if the devices behind router (A) can communicate with these behind (B).
- Copy Link
- Report Inappropriate Content
So here's what happens when I configure both routers in AP mode (dynamic IP, no DHCP).
The former main router (A) claims IP 10.108.165.230, so do all devices connected to it via WIRE. All devices connected to it via Wi-Fi claim an IP from some other pool, they start with 192.168.xxx.xxx. The other router (B) also has an IP like this - 192.168.xxx.xxx. So far the only devices that have internet connectivity are the ones connected to router A only by wire.
- Copy Link
- Report Inappropriate Content
It seems that your ISP device is in bridge mode. Do you have access to this device to check that ? What's its make and model ?
If that's the case the only way to arrange your LAN is to use router (A) in router mode and router (B) in AP mode ,but router (B) should be connected to router (A) directly, i.e you should not use the switch to connect router (B).
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
That's not a modem. This is a plain unmanaged network switch. Do you have any other device before the switch which is provided by your ISP ?
- Copy Link
- Report Inappropriate Content
The ISP cable runs directly into the network switch (it's my own, not the ISP's), then the routers are connected to the switch. I'm not aware of any device that sits before the network switch.
- Copy Link
- Report Inappropriate Content
OK. So you have two options:
1)
Remove the swicth and connect roputer (A) in router mode with the ISP cable.
Connect router (B) in AP mode (DHCP off) to a LAN port of router (A).
2)
Use the switch to connect router (A) in router mode but connect router (B) in AP mode (DHCP off) to router (A) LAN port.
- Copy Link
- Report Inappropriate Content
Thanks so much for the assistance!
Can you recommend any device (other than a router) that I can buy to replace the switch?
- Copy Link
- Report Inappropriate Content
You don't need that switch except if you can't place your router (A) in that location, i.e. to extend the ISP cable to a further location.
As I posted you can just replace the switch with your router (A) connected to the ISP cable directly (in router mode).
- Copy Link
- Report Inappropriate Content
The thing is that the ISP cable is in a nook and there are also 4 other ethernet cables there which lead to various ports throughout the house and I don't think I can fit the entire router in there.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2051
Replies: 21
Voters 0
No one has voted for it yet.