Connection between eap225 and 110

Connection between eap225 and 110

Connection between eap225 and 110
Connection between eap225 and 110
2024-08-25 20:10:41 - last edited 2024-08-26 03:31:04
Model: EAP225-Outdoor  
Hardware Version: V3
Firmware Version:

Hello, 

 

I have a eap225 outdoor networks with several hops. 
 

Is it possible to add an eap110 outdoor as an hop? Cause I have a bad connection and just need it for an Tapo plug. 
 

Didnt get it running. 
 

thx

  0      
  0      
#1
Options
1 Accepted Solution
Re:Connection between eap225 and 110-Solution
2024-08-26 03:23:52 - last edited 2024-08-26 03:35:22

  @Flo81 

Do you design mesh networks? EAP110 Outdoor does not support Mesh. As a result, it cannot serve as the next hop in the network. However, if there is an Ethernet port, you can connect it to the network via an Ethernet cable, which can also help extend the wireless internet.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:Connection between eap225 and 110-Solution
2024-08-26 03:23:52 - last edited 2024-08-26 03:35:22

  @Flo81 

Do you design mesh networks? EAP110 Outdoor does not support Mesh. As a result, it cannot serve as the next hop in the network. However, if there is an Ethernet port, you can connect it to the network via an Ethernet cable, which can also help extend the wireless internet.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:Connection between eap225 and 110
2024-08-26 05:19:13

  @Hank21 yes, It's a mesh network. Ok, so I have to buy another eap225. Thx for your answer!

  0  
  0  
#3
Options