ER605 v2 ports not shown correctly in Omada

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER605 v2 ports not shown correctly in Omada

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

jaakkoja

2025-06-05 18:02:57 - last edited 2025-06-06 02:17:53

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-06-05

ER605 v2 ports not shown correctly in Omada

2025-06-05 18:02:57 - last edited 2025-06-06 02:17:53

Tags: #Controller #Routing

Model: ER605 (TL-R605)

Hardware Version: V2

Firmware Version: 2.2.6

Noticed this kind of issue that ER 605 v2 ports are not showing correctly with OC200 2.0 controller (2.19.2 Build 20250110 Rel.75724) under dashboard-> network PoE utilization widget. Instead it is showing TL-SG2428P v5.20 (5.20.11) ports but nothing as connected. Is there some setting that I have wrong? Snapshot below, under swtiches all ports are shown correctly including PoE utilization.

1 Accepted Solution

Clive_A

2025-06-06 02:17:50 - last edited 2025-06-06 02:17:53

Posts: 8362

Helpful: 4349

Solutions: 2191

Stories: 0

Registered: 2023-06-09

Re:ER605 v2 ports not shown correctly in Omada -Solution

2025-06-06 02:17:50 - last edited 2025-06-06 02:17:53

@jaakkoja

ER605 does not support PoE. There is no data provided from ER605. It does not display. It is expected.

ER605 v2 ports not shown correctly in Omada

ER605 v2 ports not shown correctly in Omada

Information

Voters 0

Tags