Deco Be65 remains in wifi modes
I have a set of 3 Deco be65 connected to zyxel t-54 glasfiber modem. Internet providor is odido in the Netherlands.After initial configuration i would like to set it to access point modes but that fails each time. What should i do
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Thanks for the fast reply.
Does it make any difference if we temporarily disable "EasyMesh" on the EX5601-T1?
Wait for your reply.
- Copy Link
- Report Inappropriate Content
Hi, can I have the firmware version of the Deco BE65?
Do you only connect one Deco BE65(main BE65) via an Ethernet cable to the Zyxel T-54?
I saw that Zyxel T-54 is a "Dual Band Wireless AX6000 VDSL2/Ethernet Router". Is it set in the default DSL modem router mode?
As we plan to set BE65 into "Access Point" mode, we might need to make sure there is an available DHCP router.
Wait for your reply.
Best regards.
- Copy Link
- Report Inappropriate Content
I see in the Zyxel not something regarding default DSL.So below some settings
I use EX5601-T1 (Zyxel router)
DHCPV6 is active, IPV4 and IPV6 is active, RADVD is active, Easymesh enabled
DNS from ISP
I did not change the configuration after installation
I connect only the main deco to Zyxel router, the others are connected via Wifi to the main deco
I use BE65 V2. As I have some powercrash issues I can not check the firmware version.I have the DECO router since january 2025
- Copy Link
- Report Inappropriate Content
Thanks for the fast reply.
Does it make any difference if we temporarily disable "EasyMesh" on the EX5601-T1?
Wait for your reply.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 203
Replies: 3
Voters 0
No one has voted for it yet.