Home Network Community > Feature Request (Routers) > It doesn't work when I use VPN Client and turn on IPV6 at same time
< Feature Request (Routers)
 
0
Votes

It doesn't work when I use VPN Client and turn on IPV6 at same time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

It doesn't work when I use VPN Client and turn on IPV6 at same time

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
It doesn't work when I use VPN Client and turn on IPV6 at same time
It doesn't work when I use VPN Client and turn on IPV6 at same time
2025-07-04 22:57:52
Model: Archer AX55  
Hardware Version: V1
Firmware Version: 1.3.3 Build 20240628 rel.37017(5553)

 I use VPN Client and turn on IPV6 at same time.

 

And I choice ony device A(Phone) through my VPN (NordVpn)

  All outgoing IPv4 traffic from my phone is correctly routed through my VPN. But it doesn't work on IPV6. All IPv6 traffic is directly routed to the internet causing VPN leakage.

 This is undesired and I would expect the router to block IPv6 traffic for clients which have VPN access configured to prevent traffic leakage. At least until your firmware will implement IPv6 support for the VPN client.

#1
Options
1 Reply
Re:It doesn't work when I use VPN Client and turn on IPV6 at same time
2025-07-07 08:34:04

Hi@Hear,

Welcome to our community.

 

Currently, our VPN only works with IPv4. We appreciate all your feedback and feature requests here.

While we don't have any specific details to share, I'll make sure to log this feature request and pass it along to the team.

Best Regards.

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
#2
Options

Information

Helpful: 0

Views: 348

Replies: 1

Voters 0

No one has voted for it yet.

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.