i have installed SG3428xmp for the Unifi Access points but finding difficulties in configurations of the VLans.
There are onl7 8 access points and only these ports in used for which i want to keep them in vlan 30
this switch is connected to my core sw Cisco 9300x , and the uplink is configured for both the vlan30 and the vlan21 for the LAN.(remining ports of the cisco is LAN)
what i need is the exact commands to put all 8 AP's to VLAN 30 and for the trunk to configured. 
and the static route to the gateway of the vlan 192.168.32.1

as i am from Cisco world and doesn't have an good command on TP-link