Tagged untagged VLAN
Hello,
I'm a bit confused to configure network with VLAN, below is the scheme and settings I would like to make.
I read that the same port cannot be untagged on multiple VLANs,but the configuration interface allows me to do so.
Which ports should I tagged?
Best regards,
Paolo
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
For VLANs to work, you will need to have a router (gateway) to manage the VLANs (DHCP services, etc.) and provide the proper routing, especially in your case where you are using Easy Smart switches with limited capabilities.
- Copy Link
- Report Inappropriate Content
Guides you could use for knowledge and setup:
How to Set Up VLAN Interface on the Omada Router
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Is your modem/router VLAN capable? That question needs to be answered first before looking at your tagging configuration.
- Copy Link
- Report Inappropriate Content
@jra11500 Hi, thanks, my modem is Fritz 7590, no vlan capable
devices on different VLANs must not communicate but go out to the web and PC1 must be able to access configuration interfaces on VLAN 400 and 300.
VLAN 200/300/400 go out to the web
- Copy Link
- Report Inappropriate Content
For VLANs to work, you will need to have a router (gateway) to manage the VLANs (DHCP services, etc.) and provide the proper routing, especially in your case where you are using Easy Smart switches with limited capabilities.
- Copy Link
- Report Inappropriate Content
Guides you could use for knowledge and setup:
How to Set Up VLAN Interface on the Omada Router
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 166
Replies: 5
Voters 0
No one has voted for it yet.